3 major misunderstandings and common solutions in the use of electric heating

Misunderstanding 1

 Some people think that the floor heating system is turned on when the room needs to be heated, and the floor heating system is turned off when going out, thinking that this will save electricity.

The floor heating system is a low-temperature heating system, and the heating cables are buried in the cement layer or the floor, so the floor heating system has good heat storage performance. In this case, the performance of the floor heating has a hysteresis, that is to say, it takes a certain amount of time to turn on the system before the room temperature reaches the set temperature, and the room temperature will not drop rapidly after the system is turned off, and it will take a long time for the temperature to drop. Frequent switching will not only not have the effect of energy saving, but It will increase the operating cost of the floor heating and reduce the service life of the floor heating.

 * Solution:

 You can lower the temperature by a few degrees in a room that is not frequently used. You only need to lower the temperature when you are away for a long time. You can choose to turn off the system only when there are no people or when you are away for a long time. However, it should be noted that if the room has Equipment or pipes and items that are afraid of freezing, cannot shut down the system, and need to be adjusted to an anti-freezing state.

 Misunderstanding 2

 Set the high temperature to heat up quickly. Some users feel that the room temperature is low. If they need to heat up quickly, they set the thermostat's temperature to the highest. This approach is also wrong. The heating time of the room depends on the indoor and outdoor temperature difference, the installed power per unit area of the room, and the insulation of the house.

 In the case of a certain difference between the installed power and the outdoor temperature, no matter how many degrees you set the thermostat, it will always take a certain time for the room to rise to the temperature you need. In this case, you set the temperature of the thermostat Setting it to 18 degrees is the same time as 25 degrees.

 * Solution:

 Set as many degrees as you need. The current thermostats are all smart thermostats. Just set the opening time and temperature in advance.

 Misunderstanding 3

 All thermostats are the same. Many users set the temperature according to their own needs when setting the temperature, but they cannot achieve the set heating effect after the temperature is set. There are two cases. One is that the thermostat is not set correctly, because there are many types of temperature control, including room temperature type, ground temperature type, and dual temperature type, and the dual temperature type can also choose different modes. Some floor heating's low-temperature settings are too low, the low temperature is reached quickly, but the room temperature has not reached the set temperature, so some people will say that the floor heating is not hot, and the effect is not good.

 In addition, the set temperature is the same, but the temperature of each room feels different. This is related to the position of the room thermostat. If the thermostat is installed near the door, window, outer wall, etc. where the heat dissipation is relatively large, the temperature displayed by the thermostat is not high, the room temperature is already very warm. This can set the temperature of the thermostat according to the actual situation to avoid unnecessary waste.

 * Solution:

According to the different models of the thermostat, set the required temperature. The correct use of the temperature control system is also an important factor for the energy saving of the floor heating system. In addition, the relevant specifications should be followed during the use process, and the floor heating should not be affected by wrong use. Effect.